CSCS Mock Test Full 50 Questions 2024

This CSCS mock test is a full 50-question example designed to help you practice and prepare for your real Health, Safety and Environment Test in 2024. All the questions will be pulled at random from some of the core health and safety topics covered in the real CSCS test.

For the real test, you will have 45 minutes to complete 50 multiple-choice questions, you’ll need to demonstrate that you have a good theoretical knowledge of many health and safety topics before you can pass your test and apply for your CSCS card.

Most of the questions in the real test will require a single answer but there are a few which require multiple answers. In keeping with this format, we’ve added questions that require multiple answers so you can get the full experience when attempting any of our CSCS mock tests.

If a question requires two answers, you’ll need to choose both correct answers before you can get a full point for that question, so please ensure that you read each question carefully. The pass mark for this CSCS mock test is 45 out of 50. Good luck!

1. All unsafe working practices should be reported immediately; whose responsibility is it to report unsafe working practices?

Question 1 of 50

2. What should you do if a fire breaks out and you’ve not been trained to use a fire extinguisher?

Question 2 of 50

3. What should you do if the guard from a power tool you need to use is missing?

Question 3 of 50

4. Which hazardous substance is often found in cement-based roofing sheets?

Question 4 of 50

5. To ensure maximum protection when using a mask you should ____.

Question 5 of 50

6. What does the health and safety sign below mean?

safety-sign-10

Question 6 of 50

7. You stumble upon a rare plant or animal that is protected by law, which TWO activities below would be considered illegal? (Choose 2 answers)

Question 7 of 50

8. What does the health and safety sign below mean?

safety-sign-40

Question 8 of 50

9. If you need to operate a power tool you must be:

Question 9 of 50

10. What should you do if your supervisor asks you to drive a truck but you have never driven one before?

Question 10 of 50

11. Are you responsible for helping to reduce the amount of waste created on-site?

Question 11 of 50

12. Which of these is true about using gloves while handling chemicals?

Question 12 of 50

13. Being exposed to engine oil can cause ____.

Question 13 of 50

14. All of the following statements are true about using podium steps EXCEPT:

Question 14 of 50

15. Hazardous substances can be identified by ____.

Question 15 of 50

16. High levels of dust can be inhaled when performing tasks such as grinding, drilling, sanding and cutting. These levels are most dangerous when:

Question 16 of 50

17. Wet chemical fire extinguishers are identified by which colour?

Question 17 of 50

18. Guard rails placed around the top of an excavation are meant to ___.

Question 18 of 50

19. What does the health and safety sign below mean?

health-and-safety-signs-yellow

Question 19 of 50

20. To help prevent injuries caused by manual handling you should do all the following EXCEPT:

Question 20 of 50

21. What should you do if the extension wire you need to use has a cut in the outer cover?

Question 21 of 50

22. What should you do if a Health and Safety Executive inspector asks you about a recent accident you witnessed?

Question 22 of 50

23. Prohibition notices are given to equipment that:

Question 23 of 50

24. What should you do if you’re given a task that requires you to wear a full body harness but you’ve never used one before?

Question 24 of 50

25. You witness a near miss and the worker involved is afraid of getting into trouble, what should you do?

Question 25 of 50

26. Using eye protection is vital for onsite safety, when should you wear eye protection?

Question 26 of 50

27. Methane gas is dangerous in confined spaces because ___. (Choose 2 answers)

Question 27 of 50

28. Why is it important for you to keep your working environment clean and tidy?

Question 28 of 50

29. What’s the first thing you should do if a worker collapses while working in a deep inspection chamber?

Question 29 of 50

30. Which of these must you do if you’re required to use an extension cable? (Choose 2 answers)

Question 30 of 50

31. How often should you replace your high-visibility clothing?

Question 31 of 50

32. What’s the FIRST thing you should do if someone who is working in a deep man hole collapses?

Question 32 of 50

33. What should you do if you accidentally cut your finger and you can’t get it to stop bleeding?

Question 33 of 50

34. What should you do if you suspect the scaffolding you are working from is unsafe?

Question 34 of 50

35. You should report all serious accidents to_______.

Question 35 of 50

36. What do yellow and black health and safety signs like the one below mean?

Health-and-Safety-Sign-11

Question 36 of 50

37. What would you do if you’re using a hammer and the head comes loose?

Question 37 of 50

38. What does the health and safety sign below mean?

Red-and-white-health-and-safety-sign

Question 38 of 50

39. Pedestrians are most likely injured by site vehicles when the vehicles are:

Question 39 of 50

40. What could happen if oxygen levels in a confined space drops below 8 percent?

Question 40 of 50

41. What does this signal mean?

Question 41 of 50

42. Who should provide the first aid box at your worksite?

Question 42 of 50

43. Information regarding your emergency assembly points will be ___.

Question 43 of 50

44. Which of these must you do if you need to run an electrical cable across an area used by vehicles? (Choose 2 answers)

Question 44 of 50

45. Hand-arm vibration syndrome or vibration white finger can be described as:

Question 45 of 50

46. Why should workers be fully trained and competent before they’re allowed to enter a confined space?

Question 46 of 50

47. What should you do if you’re working in a deep trench and you start to feel dizzy?

Question 47 of 50

48. If you have to use water to control dust while cutting you should____.

Question 48 of 50

49. Protective mid-soles in your safety footwear are designed to:

Question 49 of 50

50. What should you do if you accidentally drop your safety helmet and crack it?

Question 50 of 50


 

Like this?

Click on a star to rate it!

Average rating 4.8 / 5. Vote count: 3177

No votes so far! Be the first to rate this post.

CSCS Mock Test | CSCS Revision | CSCS Test Questions